Ender-3/Ender-3 Pro 3D Yazıcı için 235*235mm PEI Esnek Elastikiyet Sıcaklık Dirençli Tabaka
İncelemenin bir kısmı otomatik olarak çevrildi.
waste of time. Held really well on the first layer but then warped from the heat after an hour at 60 deg bed temp. now it’s permanently warped. Gone back to the glass bed again. piece of junk.
No muy contento , no vale para nada
looking good, I am not try yet. thank you
Good
Alles super
product came in good condition
Is OK
looks good,need to test it soon
még nem kaptam meg. mikor kapom kézhez?
this is a good, lightweight replacement for the glass bed I had previously. the bed temp does need to be a little higher than previously to help promote adhesion and the use of a glue stick or equivalent also helps. the bulldog clips supplied are bigger than the ones creality provide with the glass bed and so encroach more into the print area so don't bother with them. instead try and find something smaller like small French style frameless clips. they have a much smaller footprint and are just as strong as the bulldog clips.