Creality 3D® 40*40*10mm 12V Yüksek Hızlı DC Fırçasız 4010 Soğutma Fanı 3D Yazıcı CR-10 için
İncelemenin bir kısmı otomatik olarak çevrildi.
DC FAN replacement Dont try to make the connection on the connector of the printer cable. First, prepare tools and sleeves. Cut black and red wires at 10/15 cm from the fan. Prepare each wires on the new fan and printer cable. Use sleeves to make the connection and sold and retract with an iron & heater. Warning : DC Fan (wires black & red) and Controled Fan (wires Yellow & blue) are not compatible.
Ok fits perfectly on CR-10
Works great. A direct replacement to the broken fan on my CR10 Mini printer. Yes!
classic
Replaced my original that went bad after 20 hours - works great.
Works fine
Good fan, very quiet. A little pricey, compared to the 24 volt version.
worked perfectly fine :)
Ottimo
This product was easy to install and work perfectly.