Teslimat Yeri United Kingdom , USD

Müşteri Değerlendirmesi

4.96 üzerinden
Bir Değerlendirme Yaz
  • Toplam (77) İnceleme
  • (8) Görüntü
  • (0) Video
  • Tüm Yıldızlar
    • Tüm Yıldızlar(77)
    • 5 Yıldız(74)
    • 4 Yıldız(3)
    • 3 Yıldız(0)
    • 2 Yıldız(0)
    • 1 Yıldız(0)
Göre sırala:
En İyi İnceleme
  • En İyi İnceleme
  • En Yararlı
  • En Son
    • Genel:
    • Fiyat:
    • Kalite:
    • Memnuniyet:

    2020-06-12 06:25:04

    Recommended: Comes with Zero instructions. Note: Looks professionally made but definitely DIY needed. Needs strong soldering iron for cable soldering. Cap and buzzer not soldered and the "simple" tips have to be prepared (see pic).

    Yorumlar
    • Genel:
    • Fiyat:
    • Kalite:
    • Memnuniyet:

    2020-06-16 22:17:52

    needs a few mods to make better.. pen cables changed to 10awg .sharpen tips ..direct connect to battery..better lugs on ends of cable ..solder some copper down sides of board now works better than expected with small battery

    Yorumlar
    • Genel:
    • Fiyat:
    • Kalite:
    • Memnuniyet:

    2020-06-25 04:35:48

    Worms super good

    Yorumlar
    • Genel:
    • Fiyat:
    • Kalite:
    • Memnuniyet:

    2020-06-22 07:37:12

    All was ok. Works as expexcted

    Yorumlar
    • Genel:
    • Fiyat:
    • Kalite:
    • Memnuniyet:

    2020-06-05 08:52:46

    I just get it now to test it thanks

    Yorumlar
    • Genel:
    • Fiyat:
    • Kalite:
    • Memnuniyet:

    2020-05-27 08:42:54

    Super banggood !

    Yorumlar
    • Genel:
    • Fiyat:
    • Kalite:
    • Memnuniyet:

    2020-07-08 04:35:37

    Great thing. for the money and little work , it is a must have.

    Yorumlar
    • Genel:
    • Fiyat:
    • Kalite:
    • Memnuniyet:

    2020-07-04 00:33:13

    After I assembled the board with beeper, capacitor and the cables it was not working. There was no power at the welding tips. When checking the boards circuit I found this: MCU output -> drives a PNP transistor -> drives the gates of the N-ch FETs. I post a photo of the schematic: It cannot work. The diode is assembled in wrong direction (the PNP transistor will never switch on) and even if it is reversed it cannot work. The PNP transisitor is always on then because the voltage after the diode

    Yorumlar
  1 2 3 4 5 6 7 8 9 10  

İlginizi çekebilir

Memnuniyet anketi

Uygulamayı İndir özel 10% indirim kuponunu kap