Construction is a bit tricky but not impossible. Trim a few mm off of the screw used to attach the wing. It is too long. Use a very good philips head screwdriver because the metal is soft and will strip out easily. Loosen the set screw that holds the elevator pushrods before attempting to attach the v-tail. I had to remove some material to make a proper channel through the elevator for the pushrods. I had to remove some material from the fuselage to make room for the ESC and receiver, as well as some material from the canopy interior. Receiver and battery will be a tight fit. Attach control horns to pushrods before gluing control horns to elevators. Make sure all of this is even (elevators neutral) before retightening the lag screw to secure the pushrods to the servo horn. My package did not include contact cement, I used "shoe glue".

Construction is a bit tricky but not impossible. Trim a few mm off of the screw used to attach the wing. It is too long. Use a very good philips head screwdriver because the metal is soft and will strip out easily. Loosen the set screw that holds the elevator pushrods before attempting to attach the v-tail. I had to remove some material to make a proper channel through the elevator for the pushrods. I had to remove some material from the fuselage to make room for the ESC and receiver, as well as some material from the canopy interior. Receiver and battery will be a tight fit. Attach control horns to pushrods before gluing control horns to elevators. Make sure all of this is even (elevators neutral) before retightening the lag screw to secure the pushrods to the servo horn. My package did not include contact cement, I used "shoe glue".

Construction is a bit tricky but not impossible. Trim a few mm off of the screw used to attach the wing. It is too long. Use a very good philips head screwdriver because the metal is soft and will strip out easily. Loosen the set screw that holds the elevator pushrods before attempting to attach the v-tail. I had to remove some material to make a proper channel through the elevator for the pushrods. I had to remove some material from the fuselage to make room for the ESC and receiver, as well as some material from the canopy interior. Receiver and battery will be a tight fit. Attach control horns to pushrods before gluing control horns to elevators. Make sure all of this is even (elevators neutral) before retightening the lag screw to secure the pushrods to the servo horn. My package did not include contact cement, I used "shoe glue".

nice EPO quality, V-tail is a bit fuzzy...(adjusting the linkages properly). CG between 32 and 35mm, pay attention to lipo positioning (with 2S, 450mAh). flies great, enough climbing power, glides well, although feels more comfy under power.

nice EPO quality, V-tail is a bit fuzzy...(adjusting the linkages properly). CG between 32 and 35mm, pay attention to lipo positioning (with 2S, 450mAh). flies great, enough climbing power, glides well, although feels more comfy under power.

nice EPO quality, V-tail is a bit fuzzy...(adjusting the linkages properly). CG between 32 and 35mm, pay attention to lipo positioning (with 2S, 450mAh). flies great, enough climbing power, glides well, although feels more comfy under power.