Müşteri Değerlendirmesi

Bir Değerlendirme Yaz
  • Toplam (13) İnceleme
  • (4) Görüntü
  • (1) Video
  • Tüm Yıldızlar
    • Tüm Yıldızlar(13)
    • 5 Yıldız(12)
    • 4 Yıldız(0)
    • 3 Yıldız(1)
    • 2 Yıldız(0)
    • 1 Yıldız(0)
Göre sırala:
En İyi İnceleme
  • En İyi İnceleme
  • En Yararlı
  • En Son
Yalnızca ülkenizden yorumlar (Turkey)
|
Orjinali göster

İncelemenin bir kısmı otomatik olarak çevrildi.

  • Laurie
    AU
    09/08/2019

    Very simple, two channel differential thrust plane that required almost no assembly. All you do is glue on the fin, and a tube of glue is supplied for that purpose. There are also 3 wheels that plug into slots on the wings and fuselage, but you can fly without those, and they are easy to remove and refit. The inner two engines have motors fitted, but the outer ones are just dummies, but they have propellers that spin with the slipstream. The motors are 8x20 brushless which give more than enough power. The props rotate in opposite directions, and a spare of each type is supplied, as well as a 450mAh flight battery and a charger for the battery that plugs into a USB port. There are couple of problems you should fix or you will be disappointed. 1. The propellers are not a tight enough fit on the motor shafts, so as soon as you throttle up they will fly off. You can fix this y putting a piece of thread through the shaft hole on the propeller, which goes right through to the front. Then push the prop back on so the thread is trapped. It also doesn't hurt to wick a tiny amount of CA glue (superglue) through the front of the prop so it gets onto the shaft and the thread. Cut off any thread that sticks out using a modelling knife or razor blade. 2. The model won't climb, no matter how much throttle you apply, unless you do some work on the elevators to give it just a tiny bit of up elevator. About 2mm up at the trailing edge of each elevator is enough. First you need to cut away two tiny pieces of foam that join the elevators to the rest of the horizontal stabilizer and to the fuselage, so that the elevators become free to move. I used two tiny pieces of toothpick stuck into the fuselage to lift the elevators just enough, then a very small piece of sticky tape to hold them in position and stop them from moving in flight (see photo). With these changes, the plane will fly quite well. The gyro makes it very stable.

    Yorumlar
    Orjinali göster
  • 19/06/2020

    This is actually a pretty good scale model of a B-17 Flying Fortress. which is why I bought it, since it was my intention to paint it up more realistically and modify it a little to add some realism to it. It flies very well and looks great in the air. Here is a picture of mine after I jazzed it up a bit with some silver paint and some additional markings.

    Yorumlar (1)
    Orjinali göster
  • 18/08/2019

    good plane but a bit expensive and has two motors and not 4 so don’t be fooled by the pictures. not like me anyway lol . recommend perfect for beginners.

    Yorumlar
    Orjinali göster
  • 29/09/2020

    Great model airplane! It flys well with 4 g added noseweight. I bought one again. I painted with acrilyc model paints to look more realistic. There is an old 1/72 scale Matchbox B-17 G next to it.

    Yorumlar
    Orjinali göster
  • 12/08/2020

    Lim Ting says flies tail heavy! ensure propellers are snugly attached prior to watching propellers fly away. may remove outboard propellers for better quiet flight outboard props work on inboard engines. also there are cutaways to add a servo for elevator control. however current electronics do not support.

    Yorumlar
    Orjinali göster
  • 29/09/2020

    Great model airplane! It flys well with 4 g added noseweight. I bought one again. I painted with acrilyc model paints to look more realistic. There is an old 1/72 scale Matchbox B-17 G next to it. I added the modified landing gears.

    Yorumlar
    Orjinali göster
  • UMMVIP5
    JP
    29/12/2019

    I fly very well. You can also take off and glide. The coloring is "FaddyDuddy", I love it. If possible, I wanted the white body to be painted silver. You can be happy with OpenTx + MultiModule (Fx816 protocol).

    Yorumlar
    Orjinali göster
  • 20/10/2020

    ottimo prodotto e consegna tempestiva++++

    Yorumlar
    Orjinali göster
  • 29/09/2020

    Great model airplane! It flys well with 4 g addeg noseweight.

    Yorumlar
    Orjinali göster
  • 24/02/2020

    very nice little plane

    Yorumlar
    Orjinali göster
Show:

    Toplam 0 sayfaları

    Sayfaya git

    Git

    İlginizi çekebilir

    recommendation for you
    • TRY1,939.52
    • TRY448.42
    • TRY1,527.35
    • TRY1,454.61
    • TRY593.89
    • TRY302.95
    • TRY1,357.63
    • TRY1,575.84
    • TRY3,733.69
    • TRY399.93
    • TRY3,273.02
    • TRY1,575.84
    • TRY2,533.54
    • TRY484.79
    • TRY694.76
    • TRY218.09
    • TRY1,090.93
    • TRY545.40