This is without a doubt the best upgrade you can make for your 3D printer to lower the amount of noise it makes! I had to reverse my motor plugs because for some reason it swapped the motor direction when I put them in. And make sure you do not put them in backwards! compared to the old drivers these look backwards but they are not. Check your wiring carefully before putting them in. I only swapped out X and Y but the difference in noise level is amazing! Now I need quieter fans LOL! Well worth the upgrade. My printer is quiet as a mouse now!

This is without a doubt the best upgrade you can make for your 3D printer to lower the amount of noise it makes! I had to reverse my motor plugs because for some reason it swapped the motor direction when I put them in. And make sure you do not put them in backwards! compared to the old drivers these look backwards but they are not. Check your wiring carefully before putting them in. I only swapped out X and Y but the difference in noise level is amazing! Now I need quieter fans LOL! Well worth the upgrade. My printer is quiet as a mouse now!

This is without a doubt the best upgrade you can make for your 3D printer to lower the amount of noise it makes! I had to reverse my motor plugs because for some reason it swapped the motor direction when I put them in. And make sure you do not put them in backwards! compared to the old drivers these look backwards but they are not. Check your wiring carefully before putting them in. I only swapped out X and Y but the difference in noise level is amazing! Now I need quieter fans LOL! Well worth the upgrade. My printer is quiet as a mouse now!

соответствует

соответствует

соответствует

Thank you the product arrived strong packaging very good.

Thank you the product arrived strong packaging very good.

Thank you the product arrived strong packaging very good.

sind ok

sind ok

sind ok

Basically plug and play in my A10 printer. Only had to enable them in Marlin and re-flash. Installed only on x and y axis, but that made a huge noise difference.

Basically plug and play in my A10 printer. Only had to enable them in Marlin and re-flash. Installed only on x and y axis, but that made a huge noise difference.

Basically plug and play in my A10 printer. Only had to enable them in Marlin and re-flash. Installed only on x and y axis, but that made a huge noise difference.

ok

ok

ok

CHEGOU, TUDO CERTO, OTIMO PRODUTO.

CHEGOU, TUDO CERTO, OTIMO PRODUTO.

CHEGOU, TUDO CERTO, OTIMO PRODUTO.

Good product as expected. the delivery delays must be inproved.

Good product as expected. the delivery delays must be inproved.

Good product as expected. the delivery delays must be inproved.