Teslimat Yeri United Kingdom , USD
Banggood'da %s için En Olumlu Yorum, Banggood'da en düşük fiyata en iyi %s satın alın. Satın almadan önce %s için en yararlı olumlu incelemelere göz atın., rc oyuncaklar, eğlenceli sporlar, moda, popüler elektronik
acanthurus 28/09/2020
Used this to combine an old Multiplex MC3030 transmitter with a "green pcb" Cheerson CX-10. Binding according to the described stick input worked on the first attempt - i had to reverse several servo channels afterwards in order to fly the drone. The module can be hooked up directly to an AETR-sorted PPM sum signal. I used a 9 channel protocol (the recommended 12ch is apparently not a hard requirement) The module has an on-board 78M05 voltage regulator, so it can be supplied from voltages starting from about 7V. In my case, i could directly hook it up to the DIN connector of the Multiplex transmitter without ANY additional components. There are 3 soldering pins (GND, VCC and PPM) easily accessible. This seems to be a port of one of the solutions proposed at RCGROUPS, it runs und an ATMEGA microcontroller and has the RF module piggybacked. It´s equivalent to the RCgroups DIY solution, but very competitively priced and saves a lot of bother.
0
Yorumlar
Gönder
Memnuniyet anketi

Uygulamayı İndir özel 10% indirim kuponunu kap