It works great but there is not a lot of documentation. It draws 36W at 12V (resistance is 4 Ohms). The thermistor is 100k type. When connecting thermistor to motherboard connect GND and SIG as shown in picture. It could reach 90C in about five minutes. Distance between the screw holes is 112mm. I hope this clears things up a bit!

It works great but there is not a lot of documentation. It draws 36W at 12V (resistance is 4 Ohms). The thermistor is 100k type. When connecting thermistor to motherboard connect GND and SIG as shown in picture. It could reach 90C in about five minutes. Distance between the screw holes is 112mm. I hope this clears things up a bit!

It works great but there is not a lot of documentation. It draws 36W at 12V (resistance is 4 Ohms). The thermistor is 100k type. When connecting thermistor to motherboard connect GND and SIG as shown in picture. It could reach 90C in about five minutes. Distance between the screw holes is 112mm. I hope this clears things up a bit!

The item works as it should be, but you have to be careful! Before building it in, it needs a little work. The colors and the labels do not match! You have to figure out, witch cable goes-where-and-do-what. Otherwise it could easily reach my needed 65°C from a a12V 2A power supply.

The item works as it should be, but you have to be careful! Before building it in, it needs a little work. The colors and the labels do not match! You have to figure out, witch cable goes-where-and-do-what. Otherwise it could easily reach my needed 65°C from a a12V 2A power supply.

The item works as it should be, but you have to be careful! Before building it in, it needs a little work. The colors and the labels do not match! You have to figure out, witch cable goes-where-and-do-what. Otherwise it could easily reach my needed 65°C from a a12V 2A power supply.

I received the board with an transport damage, so I can't use it.

I received the board with an transport damage, so I can't use it.

I received the board with an transport damage, so I can't use it.

ok

ok

ok

good quality

good quality

good quality

for my CNC

for my CNC

for my CNC

Nice little bed but it was tough figuring out the wiring. The answers are out there on the web though

Nice little bed but it was tough figuring out the wiring. The answers are out there on the web though

Nice little bed but it was tough figuring out the wiring. The answers are out there on the web though

Good heater! I adjusted it for the Tronxy X1 printer with alteration of the desktop, the printing of ABS and other high-temperature plastics became excellent!

Good heater! I adjusted it for the Tronxy X1 printer with alteration of the desktop, the printing of ABS and other high-temperature plastics became excellent!

Good heater! I adjusted it for the Tronxy X1 printer with alteration of the desktop, the printing of ABS and other high-temperature plastics became excellent!

sono molto sodisfatto di quello che ho comprato e lo con siglio vivamente ancora grazie perche anche il formato e quello giusto per me

sono molto sodisfatto di quello che ho comprato e lo con siglio vivamente ancora grazie perche anche il formato e quello giusto per me

sono molto sodisfatto di quello che ho comprato e lo con siglio vivamente ancora grazie perche anche il formato e quello giusto per me

be careful with the wiring

be careful with the wiring

be careful with the wiring