Teslimat Yeri United Kingdom , USD
Banggood'da %s için En Olumlu Yorum, Banggood'da en düşük fiyata en iyi %s satın alın. Satın almadan önce %s için en yararlı olumlu incelemelere göz atın., rc oyuncaklar, eğlenceli sporlar, moda, popüler elektronik
Jayjay63737 16/01/2020
I tested the flight controller with a DSMX receiver but it don't work. I also try with a frsky receiver (ibus and ppm) and it don't work too. I used UART1 and UART2 ports but they both don't work. I made a video : https://youtu.be/qbzpWaPqbYY
5
Yorumlar (5)
Gönder
  • Matt051 I tried two different types of Flysky receivers on the board and still had no luck. Done exactly the same as you tried ibus and sbus. Did you have a go at soldering the signal to the R2 solder pad? I didn't have much luck coming from it but you might. l also tried bridging the two DSM solder pads, to see if that would work. Still no luck it was a waste of money.

    Cevap 21/01/2020
  • Jayjay63737 give a try with the rx serial of uart2 activated instead of uart1. I watch Gal Kremer's video :https://www.youtube.com/watch?v=YIeMWRVbKCw

    Cevap 09/02/2020
  • SlaughterMitch You need to bridge the DSM pads. Conect both solder pads on the left, next to G, 5v and S. It works for me. Flysky reciever (Fli 14)

    Cevap 17/03/2020
  • Matt051 @SlaughterMitch I have tried everything, even flashing it with the Geprc firmware some people mentioned they managed to get it to work by doing so. The only way I got it to fly is when I threw it down the end of the garden, then straight into the bin. It eventually packed in, it wont even light up when power on with battery, worse product I have ever bought.

    Cevap 08/04/2020
  • OPELFRIK I have DSMX RX with SBUS output normaly connected and Works for me. But you must choose in BF UART2 for Receiver and VTX is onUART1 TX1. I also find 3.3V soldering pad for Spektrum RX if someone is interesting.

    Cevap 20/05/2020
Memnuniyet anketi

Uygulamayı İndir özel 10% indirim kuponunu kap