Banggood

this is excellent and it was easy to install on an skr mini E3 v2. I'm using it only to level using the dedicated bltouch port on the mainboard. I am still homing to z using the normal microswitch. little to no chance of me digging into the bed when homing. perfect adhesion every time! thanks!!

El envío llego en tiempo aceptable y el embalaje correcto. Solo queda probarlo.

was hoping for clear but works nice wire length

looks good, not tested yet..

good

Tutto ok.

works nice in my Tevo Tarantula Pro.

Works as hoped after a lot, a lot of troubleshooting. It did ruin my printer by smashing in the bed a few times. Really need to use the extra delivered connectors when they fit your printer. By using the black ones the connection isn't good and will give you lots of issues. So solder the right connectors, important! Also, glue them in place. The smallest connection issue makes it not work and lets your nozzle press into the bed until all is broken. I would recommend! Assuming you are careful. (not

I found the cable a little short to run inside the cable sleeve otherwise it was an easy install on an SKR E3 Mini 2.0 using the already compiled firmware download from the Bigtree github.

The harness turned out to be a bit too short for comfort to install on an Ender 3 Pro, I had to extend the wires about 10 cm in order to have proper service loops. Other than that, it's been very functional and repeatable.