chilledoutuk
İçeriklerim
Tüm Mesajlar
İncelemeler
Yorumlar
cevaplar
Sorular

Tüm Mesajlar

chilledoutuk itsnext to a vtx antenna how long does it take to get a lock with clear sky and more than 10cm from an high output antenna?

pothman 03/03/2020
I bought both the BN-220 and this one to compare. I love the small size of this one. It is great. However compared to the BN-220 it takes about 4-5 minutes longer to cold start. Once it does get a lock its great. But just be aware of how long it takes to begin.
Beitian En Küçük Mini Çift GLONASS+GPS BN-180 Mikro Çift GPS Anten Modülü UART TTL İçin CC3D F3 RC Drone Uçağı
US$25.82 US$51.59
1
Yorumlar (2)

chilledoutuk cablestoo tight lol

Micah 15/05/2018
This esc is waaaay underrated!
30.5x30.5mm Racerstar REV35 35A BLheli_S 3-6S 4In1 Fırçasız ESC İçindeki Akım Sensörü DShot600 Destekleyen RC Drone FPV Yarışı İçin
US$49.99 US$37.99
0
Yorumlar (2)

chilledoutuk Notsure what you mean but if you had a clue you might know this frame was designed for full size 1177 style cameras.

nkYellOw 28/05/2018
its a joke? frame for fpv racing without hole for fpv camera :(((((((((
Realacc X210 214mm 3mm/4mm Karbon Fiber Frame RC Drone FPV Yarışı w/ Matek PDB-XT60 5V ve 12V
US$28.89 US$34.66
0
Yorumlar (2)

chilledoutuk Youprobably just killed your FC because anti taz was disarming your drone.

BG561817153 20/10/2018
I've had it with this board. Yesterday my drone cut out when I was turning it. Then I found out that whenever the drone flips quickly the whole drone gets turned off. So if I was to spin the drone with my hand fast it would disarm/turn off. I thought it was the motors and the ESCs. I've spent a whole day de-soldering and soldering motors etc. No luck. Eventually I started looking at the gyro. The ribbon is very fragile. I heated it up a bit with a soldering iron to see if there was something broken there and the gyro stopped responding entirely. You get a spare ribbon cable in the box, so I tried to replace it. The paths that you solder the ribbon to are so insanely fragile that 2 came off just after I added a tiny bit of solder. I've done these ribbons on mobile phones a 100 times and these just fell apart. On top of that, I've been trying to get some support from Holybro in the past in regards to RSSI and current sensing, as Current sensing isn't even mentioned in the manual or the schematics of the board. The support always just replies with 1 sentence, no kindness, no professional help. It's as if the support was just covered by a grumpy man that does not care. Now my board is useless because of that gyro.
Holybro Kakute F7 V1.5 STM32F745 Uçuş Kontrol W / OSD Barometre için RC Drone
US$53.99 US$64.99
0
Yorumlar (2)

chilledoutuk thiscan be used for more than just a racing drone in fact it will work great on any drone so a barometer is not useless. I wish people would stop complaining about things having stuff they dont need why does it even matter.

Cornel 13/01/2019
Actually running ArduCopter on it. 3.7-dev edition, to benefit from internal serial inversion to pass FrSky telemetry over a simple wire to the XSR receiver. In the 8-pin connector, there's the undocumented 5th pin (marked I) which is for current sense. I'm using a Mauch PL-100 atm, and it's almost as big as the FC itself so I'm not happy, but it's accurate down to 10 mAh. Less then stellar is the barometer, which for most is a useless contraption, given it's a racing FC. Not bad, as I've seen and experienced worst, but far from the MS5611 which is holy writ in the autonomous world.
Holybro Kakute F7 V1.5 STM32F745 Uçuş Kontrol W / OSD Barometre için RC Drone
US$53.99 US$64.99
1
Yorumlar (1)

Uzmansın, yardım edebilir misin?

Sizi Davet Yanıtı e-postasına abone olmaya içtenlikle davet ediyoruz!

Abone olursanız, sizi e-posta yoluyla insanların ürünlerle ilgili sorularını yanıtlamaya davet edeceğiz. Size abone olarak] ayrıca "Yararlı Rozeti " kazanacaksınız! Gizlilik ayarları sayfasından istediğiniz zaman aboneliğinizi iptal edebilirsiniz.

Başkalarına yardım edin ve daha mutlu olun!

  • Abone ol

Rozetler Hakkında

Rozetler toplulukla ilgilidir ve kullanıcılar kaliteli içerik oluşturarak, görevleri tamamlayarak veya özel etkinliklere katılarak rozet kazanırlar. Belirli kişilerin kendi özel rozetlerine sahip olmaları gerekir.
CEO ROZETİ

The CEO ünvanı yalnızca Banggood patronuna aittir.

Kazanabileceğiniz rozetler yakında geliyor
  • TAMAM

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • TAMAM

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe