Tüm Mesajlar

Q: 200W so small very impossible

Soran BearLionKing Açık 2020-07-06 03:14:07

jimbob6 The answer is in the rest of the spec 5.5v x 3A is 16.5W I think they meant to say 20W not 200W although 20 is still too high.

2020-08-07 11:52:53 Yararlı (1)
cevaplar (2)

jimbob6 kinda its arduino based and port A0-7 is available so if the grbl firmware you are using has the interface hooked in there then you could get it to work. you might need to get a bit hacky with it though but if you are unsure about your abilities in this regard, bangood has a controller board that comes with an offline controller for only an extra $10. https://www.banggood.com/3-Axis-GRBL-USB-Driver-Offline-Controller-Control-Module-LCD-Screen-w-Controller-Board-SD-Card-for-CNC-1610-2418-3018-Wood-Router-Laser-Engraving-Machine-p-1600206.html?rmmds=search&cur_warehouse=CN

2020-02-13 05:36:14 Yararlı (0)
cevaplar (2)

Q: can it cut plexiglass 10mm thick?

Soran LuKun Açık 2018-11-03 12:00:03

jimbob6 Ihave ran this for a while and it would easily do plexiglass, Its all about the feeds and depth of cut. you would probably want to get some upgraded end mills for it though the v-bit that it comes with is really only good for engraving.

2019-12-07 08:05:12 Yararlı (0)
cevaplar (1)

Q: Could it work with 110v power?

Soran PIGUAVE Açık 2018-09-15 09:50:25

jimbob6 Why does it have a 110v plug if it only works on 220v?

2018-09-18 08:07:11 Yararlı (0)
cevaplar (10)
jimbob6 2018-08-23 13:55:41
Yorumlar (0)

Beğenebileceğiniz En İyi İncelemeler: