Tüm Mesajlar

Goldenwas Plug usb , connect betaflight , go to CLI command : 25mw: Set vtx_power=1 save 100mw : Set vtx_power=2 save 200mw : Set vtx_power=3 save

2020-04-05 10:29:07 Yararlı (1)
Gönder
cevaplar (1)

Q: Are the motor servos analog and the aileron servos digital?

Soran Phil3915 Açık 2019-11-13 12:30:34

mococa50 acho que ambos são analógicos mas não tenho certeza. seria bom perguntar a alguém da banggood.

2020-03-25 02:39:19 Yararlı (0)
Gönder
cevaplar (1)
Phil3915 2020-02-26 10:14:57
0
Tavsiyeler
Yorumlar (0)

Beğenebileceğiniz En İyi İncelemeler:

Phil3915 2020-02-26 10:13:13
0
Tavsiyeler
Yorumlar (0)

Beğenebileceğiniz En İyi İncelemeler:

Phil3915 2020-02-26 09:52:43
0
Tavsiyeler
Yorumlar (0)

Beğenebileceğiniz En İyi İncelemeler:

Phil3915 Wuij is incorrect. This is a "buck" converter and the input voltage must be higher than the output voltage.

2020-01-22 10:50:47 Yararlı (0)
Gönder
cevaplar (4)

Q: can I convert 6v dc to 35v dc 6-8 amp

Soran ankurdabriwala. Açık 2019-12-17 05:28:08

Phil3915 No, the input voltage should be higher than the output voltage.

2020-01-22 10:41:44 Yararlı (0)
Gönder
cevaplar (2)

Phil3915 The ailerons work fine. Pitch is controlled by the elevator. As you mentioned, the ailerons are controlled by a single servo so they cannot function as elevons. I would suggest you google Steve Schumate's "Polaris" plane. Banggood sold a similar plane (RC Lander) a while back that had the same control setup. It flies very well. There are countless versions of this plane on the market. The original design was the North Star by Laddie Mikulasko years ago. I have built several from free plans available on the internet. The airframe took a few days to build but cost only a couple of dollars in material and glue. The biggest expense was the electronics. Most of which I buy from Banggood. This is a great design as it puts the elevator and rudder directly in line with the motor thrust, making this a very responsive plane.

2019-11-16 09:47:36 Yararlı (4)
Gönder
cevaplar (6)

Q: where can I fly it

Soran Timothy Mouton Açık 2019-11-03 10:51:26

Phil3915 In the air!

2019-11-05 12:08:21 Yararlı (0)
Gönder
cevaplar (1)

Q: does fit bugs3 with Landing Skid ? :) thanks

Soran maxime Açık 2017-11-22 07:34:11

Phil3915 It works fine for the bugs 3 with the long landing skids. Prop guards have to be removed (better yet, remove the prop guards and throw them away). I made a small center support that still allowed for the cheesy camera housing that comes with the bugs 3. Unfortunately these cases have been sold out for quite a while (got mine for fifteen bucks, must have been a closeout). Make sure you can see a picture of inside the case before you buy. Some similar cases will not work for a bugs 3.

2018-10-28 12:03:29 Yararlı (0)
Gönder
cevaplar (2)
Phil3915 2018-10-05 18:27:00
0
Tavsiyeler
Yorumlar (0)

Beğenebileceğiniz En İyi İncelemeler:

Phil3915 2018-10-05 18:24:44
0
Tavsiyeler
Yorumlar (0)

Beğenebileceğiniz En İyi İncelemeler:

Phil3915 2018-07-13 14:39:33
0
Tavsiyeler
Yorumlar (0)

Beğenebileceğiniz En İyi İncelemeler:

Phil3915 2018-07-13 14:37:05
0
Tavsiyeler
Yorumlar (0)

Beğenebileceğiniz En İyi İncelemeler: