Tüm Mesajlar

RAZZORR55 Hi, yes but make sure you check the wire polarity there clearly marked ,you can use most transmitters . cheers

2021-11-12 12:48:33 Yararlı (0)
Gönder
cevaplar (2)

Q: can this be compatible to some cheap Fpv goggles?thanks

Soran BG535316151 Açık 2021-10-31 09:11:39

RAZZORR55 Hi, yes it can be used with most FPV Goggles and fpv receivers ,its got forty channels to choose from,cheers.

2021-10-31 11:45:54 Yararlı (0)
Gönder
cevaplar (1)

RAZZORR55 Placeon a AUX switch toggle type up front cam on down rear cam on ,cam one is always on in up position say your front cam its the priority cam .

2021-04-18 02:44:31 Yararlı (0)
Gönder
cevaplar (1)

Q: hi, is motor mount included in this kit version?

Soran qubert555 Açık 2021-03-24 04:31:53

RAZZORR55 HI, yes a full parts pack is included ,for motor mount ,wings, batt tray etc, nice kit for money.

2021-03-25 03:24:46 Yararlı (0)
Gönder
cevaplar (2)

Q: Which receiver is the best for this system?

Soran Kbmahe Açık 2021-02-18 10:35:10

RAZZORR55 HiTESTED MINE ON PWM on a flip switch works perfect one cam on all time then flip switch for other cam ,cheers.

2021-02-19 02:25:06 Yararlı (1)
Gönder
cevaplar (1)

RAZZORR55 Hi, Jack The answer to all is no it can't ,as it as an in built diode protection to stop any voltage return and spikes as these would just blow the circuit, its a nice unit for what its intended PWM Motor control. If your worried just put a HV shunt diode in line and a suitable capacitator ACROSS MOTOR TERMINALS, hope this helps.

2021-02-11 03:12:12 Yararlı (1)
Gönder
cevaplar (3)

Q: why won’t his bind with xjt lite module?

Soran joel tempongko Açık 2020-12-24 11:37:25

RAZZORR55 The DJT XLITE is running the new access protocol but should run both were as the receiver is in ACCST D8 mode. MAKE SURE THE PROTOCOL IS CHANGED IN RADIO. 1.Connect the FC and go to CLI. 2.Write the bind command: For Betaflight 4.x bind_rx_spi For Betaflight 3.x frsky_bind 3. Activate the bind function on the radio. 4. Go to the CLI and write Save 5. Stop the bind function on the radio 6. Reboot the FC

2020-12-24 03:14:56 Yararlı (0)
Gönder
cevaplar (1)

RAZZORR55 Minecame with the circuit printed on a separate paper ,but if you use the silk screen on the board it basically tells you what goes s were.

2020-12-05 02:36:04 Yararlı (1)
Gönder
cevaplar (2)

Q: its glass lens or plastic?

Soran Dirja Winata Açık 2019-08-23 04:39:46

RAZZORR55 GLASS

2020-09-18 12:22:17 Yararlı (0)
Gönder
cevaplar (1)