Tüm Mesajlar

Q: when will this be back in stock ?

Soran keithp Açık 2019-04-06 04:29:05

Szczypior There are alternatives on the BG with similar AWG

2023-04-24 03:46:39 Yararlı (0)
Gönder
cevaplar (1)

Q: black and red wires on rear camera what is it for ?

Soran sergzadoroz Açık 2017-11-29 07:05:57

Szczypior It's for powering it. There is separate connection of the circuit required in order to rear camera to work.

2023-04-24 03:44:49 Yararlı (0)
Gönder
cevaplar (1)

Q: does it come with the transmitter

Soran BG403745454 Açık 2023-04-24 06:44:32

Szczypior This is reciever only. Transmitter has to be bought separately

2023-04-24 03:44:37 Yararlı (0)
Gönder
cevaplar (4)

Szczypior Yes, it supports all common frequencies of analog transmission

2023-04-19 02:35:55 Yararlı (0)
Gönder
cevaplar (1)

Q: hey does it come with everything needed to run controller ect

Soran rcmad94 Açık 2020-10-31 02:51:16

Szczypior This is a KIT version, so basically a plastic model without any electronics. mine came with a motor, but no ESC or receiver.

2020-11-01 12:43:26 Yararlı (0)
Gönder
cevaplar (1)

Q: Is this in stock? Do I need a special antenna for this?

Soran Sarbjit Billing Açık 2020-06-03 06:50:49

Szczypior It comes with no antenna so you need to order them separately. It uses SMA connector. Of course it's 2,4GHz reciever.

2020-06-03 06:54:01 Yararlı (0)
Gönder
cevaplar (1)

Szczypior yes, it supports 3-6S

2020-05-25 06:21:45 Yararlı (1)
Gönder
cevaplar (12)

Szczypior The communication in group is terrible. Bad comments are deleted, so Helikido is actually not right and delusional.

2020-05-21 12:11:12 Yararlı (0)
Gönder
cevaplar (15)

Q: FURYF4OSD (Legacy) or (Diatone)?

Soran dariuszkazmierczak8 Açık 2020-05-16 02:04:16

Szczypior Diatone site states it's legacy.

2020-05-16 02:16:44 Yararlı (0)
Gönder
cevaplar (3)

Q: Is the thread straight through?

Soran Sarel MVenter Açık 2019-09-02 06:22:21

Szczypior In my case it was.

2020-04-04 02:39:00 Yararlı (0)
Gönder
cevaplar (1)

Szczypior Any kind of LEDs, but keep in mind that 5V regulator has limited amperage. If you are willing to use some high power LEDs then you just take signal pad from FC and power up LEDs from other source. Of course this FC is not dedicated to any kind of LEDs manufacturer.

2020-04-04 02:38:17 Yararlı (0)
Gönder
cevaplar (8)

Q: Will the Pin of Battery Fit with Nano Fpv Camera Pin??

Soran adityash840 Açık 2018-06-15 07:19:08

Szczypior Very unlikely as this is PH2.0 and cameras use smaller plugs in most cases.

2020-03-27 05:00:38 Yararlı (0)
Gönder
cevaplar (1)