Tüm Mesajlar

Q: What LED strip connector should I use with this product?

Soran BG183915105 Açık 2021-10-04 03:06:28

CyrusMonroe If you are talking about the power LED connector....Honestly, I would desolder the one on there like i did, and solder your own. I hooked up mine to my 12v battery(with a in line resistor for power rushing limiting), and it works for a long time, over 18hours(was the time frame for my retrobrighting). That was on 1, on the other it didn't even come with a connector it was bare solder pads. Which is the best, make sure you solder it yourself. I personally wouldn't use any type of connector as they have been known to just let go after a while if moved around a lot. Soldering avoids all of this as it is a robust connection. Just use wires to jump from one to the other.

2021-10-04 04:25:57 Yararlı (0)
Gönder
cevaplar (2)

Q: how to connect 4 strip light

Soran Dev Açık 2020-06-23 02:42:39

CyrusMonroe No you don't need "a connector" you can just solder them like a normal person and they would-will fine, cut off the cord part, or desolder them-it, then solder in the other strip, it isn't hard and it only has 2 pads. Make sure you have enough power to run the lights more strips you use the more power you will need to run them at full brightness. Personally, I would stop at 3, they got less bright at 4 and 5. They were totally visible and useful for resin curing, but would have liked it to be more bright.

2021-03-31 06:49:36 Yararlı (0)
Gönder
cevaplar (4)