The Cineape25 is very solid. It's fairly well built other than a couple of small, fixable points. The power cable is thin, only 20awg. The cable tie for the ELRS receiver is poorly placed on the battery grip pad. In general, this quad seems to be a good affordable ready to fly analogue option, or a base for upgrading to digital. A full-sized Walksnail / HDZero Freestyle VTXs would be a challenge to fit, though the 1s WS board or other HDZero boards would be no issue. A longer (around 70mm) antenna cable needed for rear mounted antenna. A standard short antenna could be side mounted. The 6 bladed props don't sound too loud or bad at a mid throttle at least. They have almost a jet engine sound. The 3D prints are very clean, though I'll probably replace them with something lighter and better fitting my needs.

The Cineape25 is very solid. It's fairly well built other than a couple of small, fixable points. The power cable is thin, only 20awg. The cable tie for the ELRS receiver is poorly placed on the battery grip pad. In general, this quad seems to be a good affordable ready to fly analogue option, or a base for upgrading to digital. A full-sized Walksnail / HDZero Freestyle VTXs would be a challenge to fit, though the 1s WS board or other HDZero boards would be no issue. A longer (around 70mm) antenna cable needed for rear mounted antenna. A standard short antenna could be side mounted. The 6 bladed props don't sound too loud or bad at a mid throttle at least. They have almost a jet engine sound. The 3D prints are very clean, though I'll probably replace them with something lighter and better fitting my needs.

The Cineape25 is very solid. It's fairly well built other than a couple of small, fixable points. The power cable is thin, only 20awg. The cable tie for the ELRS receiver is poorly placed on the battery grip pad. In general, this quad seems to be a good affordable ready to fly analogue option, or a base for upgrading to digital. A full-sized Walksnail / HDZero Freestyle VTXs would be a challenge to fit, though the 1s WS board or other HDZero boards would be no issue. A longer (around 70mm) antenna cable needed for rear mounted antenna. A standard short antenna could be side mounted. The 6 bladed props don't sound too loud or bad at a mid throttle at least. They have almost a jet engine sound. The 3D prints are very clean, though I'll probably replace them with something lighter and better fitting my needs.

super produkt

super produkt

super produkt