Very strong frame, I very much doubt you would break it. Finish is nice, mine had one small chip on the upper plate. Came with standoffs for the FC and extra screws and bolts. I used 25mm standoffs for extra room and to keep the camera mount from extending above the frame. Looks to have a decent amount of room for FPV equipment. Pros: Comes with a nice PDB, camera mount and motor protectors/feet. Platic parts are not 3D printed. Cons: Only 3" props will fit. Standoffs are short. The green parts are not as bright as I would like.

Very strong frame, I very much doubt you would break it. Finish is nice, mine had one small chip on the upper plate. Came with standoffs for the FC and extra screws and bolts. I used 25mm standoffs for extra room and to keep the camera mount from extending above the frame. Looks to have a decent amount of room for FPV equipment. Pros: Comes with a nice PDB, camera mount and motor protectors/feet. Platic parts are not 3D printed. Cons: Only 3" props will fit. Standoffs are short. The green parts are not as bright as I would like.

Very strong frame, I very much doubt you would break it. Finish is nice, mine had one small chip on the upper plate. Came with standoffs for the FC and extra screws and bolts. I used 25mm standoffs for extra room and to keep the camera mount from extending above the frame. Looks to have a decent amount of room for FPV equipment. Pros: Comes with a nice PDB, camera mount and motor protectors/feet. Platic parts are not 3D printed. Cons: Only 3" props will fit. Standoffs are short. The green parts are not as bright as I would like.

Lovin this frame. Easy to build. Very stable with EMAX 1306 red bottoms, LittleBee ESCs, and Dalprop 3" tri-blade props.

Lovin this frame. Easy to build. Very stable with EMAX 1306 red bottoms, LittleBee ESCs, and Dalprop 3" tri-blade props.

Lovin this frame. Easy to build. Very stable with EMAX 1306 red bottoms, LittleBee ESCs, and Dalprop 3" tri-blade props.