sharptrack2
- İçeriklerim
- Tüm Mesajlar
- İncelemeler
- Yorumlar
- cevaplar
- Sorular
cevaplar
Q: Essa extrusora é compatível com a impressora Anycubic Kobra Go ?
Soran BG104611571 Açık 2023-01-11 14:32:42
sharptrack2 Dependson the size of the threads in your hotend, but typically they will work.
Yararlı (0)
Q: Is 8 MB PSRAM the same as 8 MB flash memory?
Soran JPe2 Açık 2023-01-05 07:08:49
sharptrack2 Yes
Yararlı (0)
Q: Hello, how much waterproof is the lazer? can I use it while swimming or diving?
Soran BG405757361 Açık 2021-11-26 14:28:27
sharptrack2 No,not waterproof.
Yararlı (0)
Q: My PCB has two solder pads marked J3. what is that for?
Soran Dolon Açık 2022-10-01 06:43:09
sharptrack2 Look at the schematic diagram that came with the kit. It shows that J3 is an extension of J1. It would allow you to daisy chain multiple boards or power 2 devices simultaneously.
Yararlı (2)
Q: is there a diagram of the connections to arduino?
Soran McNamara Açık 2022-06-01 11:25:55
sharptrack2 No,you need to have some basic understanding of what the module outputs to determine what pins to use on your Arduino board.
Yararlı (0)
Q: Is this an official Creality upgrade kit?
Soran Tom S Açık 2022-04-21 16:29:33
sharptrack2 Yes, and is easy to install. No guesswork what so ever.
Yararlı (0)
Q: how many kilograms the roll
Soran ID7MI1 Açık 2022-04-02 12:06:17
sharptrack2 The "1KG" in the description defines the total weight of filament on the roll. The "1.75MM" defines the diameter of the filament.
Yararlı (0)
sharptrack2 Probablynot. The mounting points will most likely be different. If you're handy with modifications though you could make it fit and it should work fine.
Yararlı (0)