marc_uberstein
- İçeriklerim
- Tüm Mesajlar
- İncelemeler
- Yorumlar
- cevaplar
- Sorular
cevaplar
Q: Are Machifit and German Unimat parts compatible? Thanks.
Soran vvolfcreek Açık 2020-06-19 02:26:53
marc_uberstein This ER11 has a 5mm shaft hole, make sure that fits on your spindle. The Collets support any endmills from 1 to 7 mm.
Yararlı (0)
Q: May i use this with jet and airplane aircraft?
Soran newbraski Açık 2020-05-24 00:08:16
marc_uberstein Yes, the transmitter has multiple modes for airplanes, helicopters etc. Also, with 10 channels it can pretty much control anything with the correct setup.
Yararlı (3)
Q: How can I connect a probe test for the z axis? Thats not explained on the description. Thanks
Soran albertonieto93 Açık 2020-01-27 00:24:03
marc_uberstein Can someone please answer this question. I had a look at other boards, and it seems this board is missing the SCL pin (as per other tutorials). Maybe one of the other pins that are used for connecting the Offline Controller can be used for Z Probe? Not sure. Hopefully someone can give clarity.
Yararlı (6)
marc_uberstein Yes
Yararlı (0)