Paul
- İçeriklerim
- Tüm Mesajlar
- İncelemeler
- Yorumlar
- cevaplar
- Sorular
cevaplar
Q: Can it be used on an aircraft with just motor, rudder and elevator (no ailerons)?
Soran theDaviator Açık 2020-03-25 15:36:11
Paul I am using one on my fms cub . It helps at take off and prevents groundlooping. Connect your Servo is to the out positions on the giro in my case the rudder. Then connect the leads which came with the giro from the in positions to your receiver that is rudder to rudder, ailerons to aileron, elevator to elevator . Use one free out position to connect to to your servo. In my case there was a second open aileron which I connected to channel 7 on my receiver which was a on and off switch on my radio. With this I can switch the giro on or off. The giro must lie parallel with the fuzz of the plane and nearby your receiver. Paul
Yararlı (1)
Paul Could be a loose or dirty magnet. Also check the wires connecting on the motor from the Esc . I also had a problem that one of the motor wires did not connected correclly to the motor had to solder it back.
Yararlı (0)
Q: Can I change the lens to a zoom lens?
Soran BG393183601 Açık 2021-04-13 02:39:38
Paul No it has a fixed lens
Yararlı (0)
Q: when (if ever) will conventional "Bungie" landing gear be available for is aircraft?
Soran Chordmerchant Açık 2020-09-06 02:48:15
Paul You can get it from fms rc models. Just quite expensive.
Yararlı (0)
Q: Hi. Is reciever compatible with DX8e, but in EU version of transmitter? Thanks for reply.
Soran BG936186145 Açık 2021-02-03 12:30:55
Paul Mine is working with a Dx6i tx no problem so far so it should work with the DX8i tx.
Yararlı (0)
Paul Will it work with a Jjrc x5 epik drone?
Yararlı (0)
Paul Does the screen show the date and month?
Yararlı (0)
Paul Yes
Yararlı (0)