Dario
- İçeriklerim
- Tüm Mesajlar
- İncelemeler
- Yorumlar
- cevaplar
- Sorular
cevaplar
Q: will this support all 6 motor out? i want to use it for a hexcopter?
Soran DavidHutnik Açık 2018-02-22 23:55:28
Dario Correct, you can power the FC by using a PDB and connect to the 5v pin on the underside connector or any of the 5v pads on the board.
Yararlı (0)
Q: how i can conect sbus ? what serial port i need to activate?
Soran JeanBagnod Açık 2018-02-01 23:37:44
Dario SBUS gets connected to RX6 on the board and set accordingly in BF to use SBUS
Yararlı (0)Q: Wich pad to use to power this board?
Soran sacapof Açık 2018-02-12 13:56:25
Dario You can use either the 5v wire in the underside plug or any of the 5v pads on the board.
Yararlı (0)
Dario There is no need to remap anything. The Underside plug motor signal wires and the M1-M4 pads on top of the board are the same so you can use either configuration.
Yararlı (0)
Dario Yes it sure does. If you look on top of the board next to the CRNT, 3.3v, RSSI, GND pads....you will see outputs for motors 5 and 6 (M5 & M6)
Yararlı (0)