CrashLogger
Q: could they possibly operate on 5v?
Soran Franckies Açık 2019-10-23 04:57:13
CrashLogger they can, but you need to limit the current (on any voltage) to under 40mA, preferably 20mA
2024-03-22 01:50:31 Yararlı (0)
CrashLogger you need to limit the current to under 40mA, preferably 20mA. a 220 Ohm resistor will do the trick.
2024-03-22 01:49:55 Yararlı (1)Q: why do these have 90 % fail rate, some burn, some blew up on 5 volts.
Soran jaminjimlp Açık 2023-11-10 03:48:36
CrashLogger You need to limit the current flowing through them. I have a similar set to this one, all of them are 40mA max. I would recommend sticking to under 20mA I'd you want them to last. a 220 Ohm resistor in series is more than enough
2024-03-22 01:48:51 Yararlı (1)
Q: Are there any instruction for connecting and controlling the stepper motor?
Soran Barry Açık 2019-06-02 06:36:54
CrashLogger No, you must look for that information online. it's not a complicated process though
2020-03-02 04:07:16 Yararlı (0)
CrashLogger I get that issue on one of my laptops a lot, reconnecting the board and resetting it seems to help, but si have yet to find a more permanent solution
2020-03-02 04:05:29 Yararlı (0)Q: Can I connect servos directly to this board ? I need to use three servos.
Soran mariohermoso Açık 2018-11-21 11:51:18
CrashLogger Depending on what servos they are. I've ran 2 9g servos off of mine without any issues.
2020-02-29 06:45:55 Yararlı (0)
Q: how much thrust does it have?
Soran pickle Açık 2019-07-14 08:24:08
mononocanalinfo Probably depends on your propeller size and material if you want an accurate measurement
2020-01-12 07:03:59 Yararlı (0)Sizi Davet Yanıtı e-postasına abone olmaya içtenlikle davet ediyoruz!
Abone olursanız, sizi e-posta yoluyla insanların ürünlerle ilgili sorularını yanıtlamaya davet edeceğiz. Size abone olarak] ayrıca "Yararlı Rozeti " kazanacaksınız! Gizlilik ayarları sayfasından istediğiniz zaman aboneliğinizi iptal edebilirsiniz.
Başkalarına yardım edin ve daha mutlu olun!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
.JPG)
CrashLogger It has a bearing on the stator and it is an outrunner. I can't tell if it's even possible after inspecting mine. I would recommend finding a different mount or motor...
2024-03-22 01:53:10 Yararlı (0)