Joe I used the supplied adapter plug and a very Large 110VAC to 220VAC transformer from the Philippines. It provides filters and regulating. I see these at the markets along with appliances that use the 220v. Warning - NO GROUND with the supplied adapter. The correct way is to use an electric Dryer Plug that's rated high enough for the Welder's duty cycle. Try to use a 220VAC plug that matches your dryer (Electric Dryers here in the united states are 220VAC) Your female plug might be in a laundry or better yet Garage on the wall - so find a matching male plug that's 30A-40A or better (Higher) - wire the mail plug end into the Welder (Use an electrician to double check the work before power is applied and power is applied.) The WIRE colors really are not helpful - the WIRE size is - of the 3 wires from the welder only one size wire is thinner gauge wire - mine was the ground.

Joe This Product has small enough openings for my JST connectors and is what I have used before. I did have to adjust the tension with the wheel so not to cut the connector.

Joe It's Digoo APP and it's worthless. They want you to PURCHASE a cloud server from them. There is NO support from them. I had to reinstall my APP and reset the camera - I am locked out of my Digoo camera. Digoo won't help. DO NOT BUY THIS CAMERA. DIGOO is the worst!

Joe my QR code takes me to a Chinese page I cannot read. There is NO translate or selection to change the language. Make matters worse the instructions and the default user and password text is so small it is NOT readable, even with a zoom on my cell phone - I can not read what it is saying. I am stuck too.

Joe The Dampener slash coupler is sold here too, but I am using a Stock Creality stepper. Just a note, before buying the Lead Screws and the Nuts, be warned that the Lead Screws have a different pitch from the stock screw and, if going Dual Z-Axis you might want to purchase them in pairs so they match pitch or else, one side will travel higher or lower than the other. I got lucky and picked up two at a time. I found they differ from the stock screws in turns per inch. Also, you might have to adjust the Steps for the Z-Axis since they differ from stock. Hope that could help you.

Joe Theyare pre molded and pre colored rubber masks - no customization's were available on mine. Be warned mine tore in the back - Straight up when I went to put it on at Halloween, so the rubber is VERY cheap and doesn't stretches - it tares.

Joe Ohya!! it's for the Ender V2 as it's a direct replacement with Thermal Runaway SAFETY fail-safes temp prob - the Ender V2 lacks those fail safe if there's a temperature probe wire broken or disconnect it will keep heating and heating until ............

Joe No, sorry, it's android based which is tied to your phones Location service during install. I wasn't able to install via my "Windows" or via IP Port because it's install-able ONLY through the makers Android IOS App. I've tried to reset my camera and start over with a clean install, but, it wants me to setup an account on their pay cloud service. I just want to connect to the camera's IP and control it from there but it wont connect unless you have an account setup. This setup was the worst I've ever had - basically my camera is now a brick