Tüm Mesajlar

rhe Mine does that as well. I think it may be an idiosyncrasy in the gyro controlled modes; the rudder stick command appears to demand some yaw movement of the plane, in other words it the rudder angle holds until the plane angle responds (yaw). I also notice a greater range of the rudder servo in gyro stabilized modes. I also had elevator tail wagging in flight. I haven't figured out what makes the tail wagging worse, it seems intermittent. It is probably a result of the gyro feedback gain in the control loop. I haven't tried expert mode (gyro off) yet - still learning my hand eye coordination.

2023-01-03 12:34:01 Yararlı (0)
Gönder
cevaplar (1)

Q: is it compatible with rx6r frysky receiver?

Soran BG114675331 Açık 2021-07-08 05:54:31

tester Yes

2022-11-03 07:36:42 Yararlı (0)
Gönder
cevaplar (2)

rotor400 RX vom Gps auf TX FC und TX GPS auf RX FC Plus auf 5 Volt Minus auf Ground SLC auf SLC SDA auf SDA.Dann GPS in Iflight Port zuweisen und in Konfiguration GPS aktivieren fertig ist der Akt!

2021-07-29 01:52:59 Yararlı (1)
Gönder
cevaplar (3)

Q: works for frysky rx6r receiver?, thanks

Soran BG114675331 Açık 2021-07-08 05:37:36

dengjunbao yes

2021-07-10 01:15:50 Yararlı (0)
Gönder
cevaplar (1)

lacvo In most configurations, you only need to connect the FC (Matek F765) to your PC with USB cable. in some other configurations, you also need to connect a battery to your FC for testing things like motor, sensors or anything that can not run on USB power

2021-04-26 07:22:39 Yararlı (0)
Gönder
cevaplar (1)