Tüm Mesajlar

Q: What is the max RF Power for this bridge?

Soran BG172101915 Açık 2022-01-17 11:27:44

BG321646142 Documentation indicates 100 W

2022-02-01 05:21:01 Yararlı (1)
Gönder
cevaplar (2)

Q: Is this chip genuine FTDI or clone?

Soran BG172101915 Açık 2021-02-07 10:52:48

WolfxPac how do you differentiate between them? it's open-source hardware using same USB to TTL IC.

2021-09-17 12:19:16 Yararlı (0)
Gönder
cevaplar (2)

Q: I am confused...are these straight or curved (or is it random)?

Soran rbusque Açık 2018-11-05 07:27:07

AIANTONIA Curved head

2018-11-14 08:51:16 Yararlı (1)
Gönder
cevaplar (2)

Q: What is the measurement frequency for this unit?

Soran BG172101915 Açık 2020-02-28 12:37:22

BG555247215 Thisdevice measures earth ground resistance, not the frequency

2020-11-05 01:14:14 Yararlı (0)
Gönder
cevaplar (2)

Q: What is the diameter of

Soran rbusque Açık 2018-03-28 07:10:50

PampaWak About8mm. Please permit me 1-3cm of tolerance because of manual measure.

2020-05-05 12:07:28 Yararlı (0)
Gönder
cevaplar (1)

Q: What is the diameter of ceramic insulator protecting the wires?

Soran rbusque Açık 2018-03-28 07:11:37

PampaWak Idon't know exactly, but it's about 8/10mm. Sorry for this delay, but I didn't know about this part of the website!

2019-10-18 04:55:37 Yararlı (0)
Gönder
cevaplar (1)

Q: What is the diameter of the ceramic tube?

Soran rbusque Açık 2018-03-28 07:14:18

Sandu max12.4mm, min 10.4 mm - is eliptic, not round

2019-09-17 09:25:32 Yararlı (0)
Gönder
cevaplar (1)

Q: nela pode por 2 filamento ao mesmo tempo ?

Soran ????????? Açık 2019-08-11 07:20:32

rbusque Natively,it can only handle one filament at a time. This being said, my impression is that these are highly modifiable.

2019-08-12 07:53:23 Yararlı (0)
Gönder
cevaplar (4)

rbusque Minedid not have magnetic platform. When I researched the resume function for this, though possible, it was clear there would always be some artifact in the print...I opted to not enable it. Printing can be done directly from the micro SD. Extruder is nothing fancy. I ended up installing a bed sensor for levelling...made a huge difference in repeatability.

2019-08-12 07:50:56 Yararlı (0)
Gönder
cevaplar (4)