Tüm Mesajlar

Kobie No expert on this, but with some old school electronics experience. First thing, it is not a good idea to connect diodes, transistors and that kind of components in parallel, because of thermal run away. By that I mean that the hotter the semiconductor gets, the less resistance it have, and more current flow, and the more heat is generated. So, when, for example, two diodes. When one's character slightly differ it will heat up faster than the other one, get killed, and the surviving one will have to handle all the work, and therefore get killed also. If you put a good big heat sink on the .. I think it is thyristors, the two rows of black blocks, so that all of them share the heat dissipation equally, you may get away with 100 Amps on one board. To connect them in parallel may work, but I'm somewhat worried about the small differences in character of the two boards that may cause trouble. If you want to try the parallel trick, make sure to have heat sinks on both. You may get away with it,and it will be an interesting experiment. Good luck.

2022-07-06 06:25:10 Yararlı (0)
Gönder
cevaplar (1)

Kobie Probably just with or without the 3 connecting pins CN1 installed or not.

2022-04-11 02:53:59 Yararlı (1)
Gönder
cevaplar (2)

Q: Hi I would like know if i can see it in U. S. Foot or inches

Soran BG839203714 Açık 2021-03-06 04:18:20

Kobie The tape is clearly marked in metric and inches. The laser measuring can also be selected to read in metric or inch

2022-02-21 02:52:26 Yararlı (0)
Gönder
cevaplar (8)

Q: is the wire tinned?

Soran BG393836381 Açık 2022-02-14 08:31:16

Kobie Yes, it is tinned. I have not used any of it but it visually have that nice silver look to it, and obvious good quality.

2022-02-14 09:05:22 Yararlı (0)
Gönder
cevaplar (3)