Tüm Mesajlar

erman As per others only discovered not real DZ after unboxing. the USB sensor does give manufacturer as DZTECH. I was able to flash with both the dz60 and Yd60mq_16led. In the end I went with yd60mq_ansi layout just to ensure i have all the functionality of Faux DZ60. Having been a Pok3r user I soldered my MX keys to the same location as my Pok3r added LED backlight to keys. Then proceeded to map the keys to 2 layers as per my current setup. Set up my MO(difier) key for the second layer to control the LED and LED SMD activity. compiled the keymap, downloaded the firmware. installed QMK Toolbox, plugged in the keyboard and used a paper clip to short the reset connectors on the underside. Will consider soldering in a small push button switch on future boards. All went well so likely would recommend the board at any discounted

erman 07/01/2021
1
Yorumlar (1)