Tüm Mesajlar

hf-seeker 08/12/2018
I have determined the following parameters for the supplied power supply, bottom stop: measured 3.37V, display 3.39V, no-load losses 0.14W top stop: measured 24,21V, display 24,9V, no-load losses 0,84W The ripple is considerable with about 420mV, especially in the lower voltage range. There are also much stronger needle pulses. The output circuit is therefore insufficiently filtered. I found an efficiency of just over 86%, at 24V and 40W. My measuring equipment for this are not so accurate. I would not use the power supply for computer technology. It can be used for electronics experiments above 5V and for the supply of smaller AF power amplifiers. But you should provide an additional support capacitor. Bei der gelieferten Stromversorgung habe ich folgende Parameter ermittelt, unterer Anschlag: gemessen 3,37V, Anzeige 3,39V, Leerlaufverluste 0,14W oberer Anschlag: gemessen 24,21V, Anzeige 24,9V, Leerlaufverluste 0,84W Die Welligkeit ist mit etwa 420mV erheblich, insbesondere im unteren Spannungsbereich. Es treten auch noch wesentlich stärkere Nadelimpulse auf. Der Ausgangskreis ist demnach unzureichend gefiltert. Ich habe einen Wirkungsgrad von etwas über 86% ermittelt, bei 24V und 40W. Meine Messmittel hierfür sind aber nicht so genau. Die Stromversorgung würde ich nicht für Computertechnik einsetzen. Sie ist einsetzbar für Elektronik-Experimente oberhalb 5V und zur Versorgung von kleineren NF-Endverstärkern. Einen zusätzlichen Stütz-Kondensator sollte man aber vorsehen.
20
Tavsiyeler
Yorumlar (3)

hf-seeker I made disload check with 1,0 A until 9 V.The first check reached 2,323 Ah, the second check (after repeated reloading) reached 2,513 Ah. The specification 8000 mAh probably refers to the addition of the capacity of the three cells.

2022-01-10 04:57:10 Yararlı (0)
Gönder
cevaplar (4)
hf-seeker 08/05/2019
guter Kauf/good buy Deutsch (English see below): Mein Board mit TPA3118 funktioniert ab ca. 6V. Die Bluetooth-Verbindung stoppt bei 5.8V. Ich betreibe den Verstärker mit einer 15-V-Stromversorgung, um ein Maximum von 20 W an 6 Ohm zu erreichen. Nach Datenblatt sind 2x 75W an 4 Ohm möglich, bei 24V. Dafür muss ein Kühlkörper adaptiert werden. Etwas stört mich die Geräuschreduzierung in Bluetooth. Wenn der Pegel sehr niedrig ist, wird er ausgeschaltet, um das Rauschen zu verhindern. Wenn Musik mit sillen Passagen übertragen wird, setzt der Ton aus. Es hilft nur, es lauter zu machen. Die Line-In Buchse ist parallel zu Bluetooth geschaltet. Es hängt von der Impedanz der Line-In Quelle ab, welches bei gleichzeitigem Betrieb stärker ist. Ich kann den Betrieb mit 3 bis 4 Stück 18650 Li-Ion-Akkus empfehlen. Der Ruhestrom beträgt etwa 51,5 mA (von 6 bis 26 V nahezu spannungsunabhängig). Mit 3000 mAh-Akkus erhalten Sie über 50 Stunden leise Musik oder etwa 3 Stunden maximale (schmerzhafte) Lautstärke. English: My board with TPA3118 works from about 6V. The Bluetooth connection stops at 5.8V. I operate the amplifier with a 15V power supply to reach a maximum of 20W at 6 ohms. According to data sheet 2x 75W to 4 ohms are possible, at 24V. For this, a heat sink must be adapted. Something bothers me the noise reduction in Bluetooth. If the level is very low, it will turn off to prevent the noise. When music is transmitted with quiet passages, the sound stops. It only helps to make it louder. The line-in jack is connected in parallel with Bluetooth. It depends on the impedance of the line-in source, which is stronger when used simultaneously. I can recommend the operation with 3 to 4 pieces of 18650 Li-Ion batteries. The quiescent current is about 51.5 mA (from 6 to 26 V almost voltage-independent). With 3000 mAh batteries you get over 50 hours of quiet music or about 3 hours maximum (painful) volume.
3
Tavsiyeler
Yorumlar (0)

hf-seeker Yes it is a bad product because of the terrible loudspeaker. Give the review 4 - 5 stars for it to appear ;-)

2019-11-17 04:41:05 Yararlı (0)
Gönder
cevaplar (2)

hf-seeker With 3 NiMH cells I heard radio and measured the power consumption of 25 mA. In stand by only 18 μA.

2019-11-17 04:35:13 Yararlı (0)
Gönder
cevaplar (2)

Q: How is it powered? does it have a backup battery?

Soran slyzing Açık 2018-01-22 11:45:42

hf-seeker You can use NiMH-cells, works fine. You should power by USB, if you change batteries, otherwise the settings will be lost.

2019-11-17 04:26:26 Yararlı (0)
Gönder
cevaplar (3)
hf-seeker 08/05/2019
gut und günstig/good and cheap Deutsch (English see below): Mein Board mit TPA3110 funktioniert ab ca. 6V. Die Bluetooth-Verbindung stoppt unter 5.7 V. Ich habe den Verstärker mit einer 15-V-Stromversorgung an 6 Ohm getestet, dafür ist er sehr gut geeignet. Nach Datenblatt sind 2x 37W an 6 Ohm möglich, bei 22V. Dafür muss ein Kühlkörper adaptiert werden. Bei 4 Ohm wird die maximale Leistung von 25 W bei 16 V erreicht. Etwas stört mich die Geräuschreduzierung in Bluetooth. Wenn der Pegel sehr niedrig ist, wird er ausgeschaltet, um das Rauschen zu verhindern. Wenn Musik mit sillen Passagen übertragen wird, setzt der Ton aus. Es hilft nur, es lauter zu machen. Ich kann den Betrieb mit 3 bis 4 Stück 18650 Li-Ion-Akkus empfehlen. Der Ruhestrom beträgt etwa 42 mA (von 6 bis 26 V nahezu spannungsunabhängig). Mit 3000 mAh-Akkus erhalten Sie bis 70 Stunden leise Musik oder etwa 3 Stunden maximale (schmerzhafte) Lautstärke. english: My board with TPA3110 works from about 6V. The Bluetooth connection stops below 5.7 V. I have tested the amplifier with a 15V power supply to 6 ohms, he is very well suited for that. According to data sheet are 2x 37W to 6 ohms possible, at 22V. For this, a heat sink must be adapted. At 4 ohms the maximum power of 25 W at 16 V is reached. Something bothers me the noise reduction in Bluetooth. If the level is very low, it will turn off to prevent the noise. When music is transmitted with quiet passages, the sound stops. It only helps to make it louder. I can recommend the operation with 3 to 4 pieces of 18650 Li-Ion batteries. The quiescent current is about 42 mA (from 6 to 26 V almost voltage-independent). With 3000 mAh batteries, you will receive quiet music for up to 70 hours or maximum (painful) volume for about 3 hours.
0
Tavsiyeler
Yorumlar (0)