Tüm Mesajlar

KagiriFpv sadly the schematic cannot be posted on the question bar. please follow up on that on the review sections mostly where people will post photos of the product

2021-12-04 01:40:43 Yararlı (0)
Gönder
cevaplar (2)

KagiriFpv Yes the mamba stack has an sbus driver. Normally the shipping will take close to 2 or 3 days to be shipped and based on your location the shipping time might vary check out mamba stack website on how to set up the sbus receivers such as an rsxr

2021-12-04 01:37:13 Yararlı (0)
Gönder
cevaplar (7)

Q: How to connect the dsm spektrum receiver

Soran Aldron Açık 2019-01-12 11:53:19

KagiriFpv You need to solder the reciever to the pads set out for the receiver

2021-11-21 01:42:58 Yararlı (0)
Gönder
cevaplar (3)

Q: Does this flight controller have an OSD?

Soran елисей Açık 2020-12-19 04:38:46

KagiriFpv Yes it does. when wired correctly you could use your transmitter to actually configure on you OSD

2021-11-21 01:42:18 Yararlı (0)
Gönder
cevaplar (4)

Q: Is this a stack for 40 bucks?! Really???

Soran Gilberto Açık 2018-08-29 10:17:17

KagiriFpv yes it is ...it among the most well priced stacks that still gives out a lot of functions...have it on close to 3 builds now and I haven't regretted using it

2021-11-21 01:41:30 Yararlı (0)
Gönder
cevaplar (2)

Q: Its compatible with radio master tx16S?

Soran luissrbc Açık 2021-06-10 04:49:10

KagiriFpv Yes, it is compatible mainly because your radio master tx16S is a universal transmitter.

2021-06-11 07:32:18 Yararlı (0)
Gönder
cevaplar (3)

Q: how many antennas are these?

Soran BG443537395 Açık 2020-12-04 05:15:52

KagiriFpv it only come as one antenna ...if you need 2 or more you need to indicate 2 so forth and so on

2020-12-04 05:17:50 Yararlı (0)
Gönder
cevaplar (5)

Q: Do you need a power distribution board with this flight controller?

Soran BG109239251 Açık 2020-10-10 02:32:04

KagiriFpv No you do not really need one.The stack has its own esc and the flight controller is well laid out for almost anything you would want to solder on

2020-10-11 08:43:12 Yararlı (0)
Gönder
cevaplar (11)

Q: Is it spring loaded ? if it is not which one is springloaded

Soran KagiriFpv Açık 2020-09-13 02:25:56

FredViau no it's a on or off switch no spring. this is not the failsafe switch

2020-09-13 06:05:37 Yararlı (2)
Gönder
cevaplar (1)

KagiriFpv both black wires are ground the first red wire is 7-24 volts which powers your vtx using battery voltage the other red wire can be used to pass voltage out to you camera that supports 5v out .The blue wire helps you have smart audio and the yellow wire goes into videos .Probably would you mind sharing your flight controller you plan on using then i can help you further.If you use whatsapp app me on +254703500525

2020-09-08 10:41:01 Yararlı (1)
Gönder
cevaplar (1)

Q: when will you have it back in stock?

Soran koes_24 Açık 2020-04-10 03:38:42

KagiriFpv Itsback if you want to buy ...just checked

2020-07-30 03:40:59 Yararlı (0)
Gönder
cevaplar (3)

Q: The best battery for this modulo?

Soran Vladi Puica Açık 2019-07-31 03:10:01

KagiriFpv Ipersonally run tattu rline 1350 35c when am doing aggresive flying when i just want to cruise around and master a new skill i use gen ace 2200 25c 3s for more flight time

2020-07-30 03:40:00 Yararlı (0)
Gönder
cevaplar (2)

Q: What is the size of the camera with the bracket on?

Soran rache4free Açık 2020-07-13 03:07:22

KagiriFpv lengthincreases to 28mm width still at 21.8

2020-07-30 03:36:15 Yararlı (0)
Gönder
cevaplar (2)

Q: what is the size of a milli amper for a 3 s battery

Soran BG223744250 Açık 2020-07-30 12:28:54

KagiriFpv The size in terms of capacity which is measured in MilliAmps (Mah) will depend on the KV of your motors and the amperes your electronic speed controller can with stand ...Kindly read the kv of your motors the google up the milliamps the motor can take

2020-07-30 03:32:39 Yararlı (0)
Gönder
cevaplar (5)