Tüm Mesajlar

Q: what receiver for an adfs-2a transmitter, say flysky i6s

Soran mgamba Açık 2019-09-16 05:06:50

simole88 Forgive me, but I don't understand what your question is. I don't know about the adfs-2a protocol. I know the Flysky i6S Radio transmitter which works with the AFHDS-2A protocol. This tiny receiver works with DSM2 protocol that isn't compatible with Flysky Radio unless you are using an external multi-protocol module.... If you are looking for a nano receiver like this to bind with your Flysky i6S Radio transmitter, you have to choose "Flysky FS2A 4CH AFHDS 2A mini compatible receiver PWM"

2021-10-11 07:34:02 Yararlı (0)
Gönder
cevaplar (0)

simole88 Hi, you'll need to select and upload on the "FMS Reflex Gyro System V2 flight controller" the right model everytime. It isn't the same profile for all three because the model (CG, aerodynamic and flying spec.) are different..

2021-10-11 06:28:31 Yararlı (0)
Gönder
cevaplar (0)

Q: Please, still not available in CZ warehouse ?

Soran pidi52 Açık 2021-10-08 02:36:20

simole88 At the moment it is only available at the CN warehouse. Maybe contact Bangood customer service for more information

2021-10-11 05:19:11 Yararlı (0)
Gönder
cevaplar (0)

simole88 No, this receiver works only with FrSky D16 (or D8) protocol. Alternatively you can bind it with a multi-protocol radio like these: Radiomaster TX16S, Jumper T8SG, Eachine TX16S, Jumper T-Lite, Jumper T18 or T18 PRO, Jumper T12 ... Or an external multi-proticol module compatible with your Radio transmitter if supported...

2021-10-03 11:28:23 Yararlı (0)
Gönder
cevaplar (1)

Q: What is the lowest current that can be set up?

Soran Vlad Açık 2021-10-02 07:43:29

simole88 min. current that can be set up: 1A with resolution of 0.05A

2021-10-03 10:53:47 Yararlı (1)
Gönder
cevaplar (1)

Q: does it fit Sunbird v2.0 upgrade

Soran HampusH Açık 2021-09-22 09:32:31

simole88 Hi, if you use a 3S lipo and 20A ESC, I suggest to work with 8-10 inch prop. If you use the recommended electronic, the MM2212 1100KV motor supports the following propeller: 8x4.3, 9x4.7 and 10x4.7. I do not recommend the 10x4" prop because it is excessive and requires too much power (@ 12.6 V > 17.5A > 220W > and a thrust of 750g). This foldable propeller of ASW28 is not recommended because it is a 10x6" prop..

2021-10-03 09:11:37 Yararlı (0)
Gönder
cevaplar (1)

simole88 Youcan turn the led strip ON and OFF from a physical switch (light switch) or a Wi-Fi switch. From a physical switch, however, if the LED is turn off you will not be able to turn it ON from the application on your mobile phone or google or alexa...

2021-09-26 10:01:12 Yararlı (0)
Gönder
cevaplar (1)

Q: I got dx7s and it would not bind , dsm? Or dose it hafe to be dsm2?

Soran ozzieocat Açık 2020-01-21 08:52:39

simole88 Testedand works fine with DSM2 protocol on my Radiomaster TX16S

2021-09-26 09:53:12 Yararlı (0)
Gönder
cevaplar (1)

simole88 Yes,FMS 1400mm J3 Club V4 is supported by FMS Reflex Param V2.0 You can load the model and control it from the gyro safely! I hope I was helpful

2021-09-26 09:47:24 Yararlı (0)
Gönder
cevaplar (1)

simole88 Yes, this tiny receiver (22×12mm) have an ESC output (M+ and M-) for tiny BRUSHED motor like 410 or 412 brushed motor. Also has two outputs for two micro magnetic servos (included). You can connect il to its connector ( tiny 2pin connector) or solder the cable directly. Good flight!!!!

2021-09-18 05:55:10 Yararlı (0)
Gönder
cevaplar (1)

simole88 This Battery: Uruav 1300mAh 80-160C 4S (14.8V ~19.2Wh) have a weight of 156g and real size of 34,4×28,9×73,3mm. - Balancing wire + connector have a length of 63mm (22AWG silicone wire cable) - XT60 connector + wire have a length of 130mm (10AWG high quality silicone wire cable)

2021-09-18 05:13:45 Yararlı (0)
Gönder
cevaplar (1)

Q: does this fit the radiomaster tx18 as well.thks

Soran BG401622911 Açık 2021-07-06 08:21:52

simole88 I have no idea, you could first disassemble the TX18 and check if the image of this antenna corresponds to the one mounted on yours Radio. In that case I think they are compatible, since the transmission frequency of the two radios is always the same.

2021-09-15 05:38:34 Yararlı (0)
Gönder
cevaplar (1)

simole88 I've bind this receiver with my multi p. Radiomaster TX16S: --> Internal module --> FrSky --> D8 and it works fine. With the new FrSky Radio (QX7s and newest) you can update and choose international firmware (FCC) or EU firmware (LBT) I think it's no way to update to D16.... And in this receiver you haven't possibility to connect it to your Radio or PC or download and update internal firmware.

2021-09-15 05:33:23 Yararlı (0)
Gönder
cevaplar (1)

simole88 Nella descrizione del prodotto sono riportati tutti i modelli che questo dispositivo "Universal 280-868 MHz Garage Door.." è in grado di copiare. Assicurati che il telecomando che stai per copiare sia Master e non Slave. Master: premendo un tasto qualsiasi del telecomando da copiare, il led lampeggia e poi diventa stabile. Slave: premendo un pulsante qualsiasi il led è subito fisso. Spero di esserti stato utile

2021-09-15 05:09:31 Yararlı (0)
Gönder
cevaplar (1)
simole88 15/06/2020
1
Tavsiyeler
Yorumlar (0)